Using The Embedded Web Server; Accessing The Embedded Web Server; Enter Network Password Dialog Box - HP StorageWorks Installation Manual

3

Using the Embedded Web Server

If an HAFM appliance is not available, or is not used to manage the switch, use the Embedded
Web Server (EWS) interface to configure the Edge Switch 2/24. Selectively perform the following
configuration tasks according to your installation requirements:
• Configure switch
• Configure switch and fabric
• Configure network
• Configure SNMP trap message
• Enable or disable the
• Configure user
NOTE: This chapter describes the initial setup of the Edge Switch 2/24 using the EWS interface.
For additional information on configuring more advanced features using EWS, see the online EWS
help or the HP StorageWorks Embedded Web Server user guide.

Accessing the Embedded Web Server

A PC platform with LAN access and standard web browser running Netscape Navigator 4.6 or
later or Microsoft Internet Explorer 4.0 or later is required.
To open the Embedded Web Server interface:
1. Ensure that the browser-capable PC and the Ethernet LAN segment (with the switch attached) are
connected.
2. At the PC, launch the browser application (Netscape Navigator or Internet Explorer).
3. At the browser, enter the IP address of the switch as the Internet uniform resource locator (URL).
Use the default IP address of 10.1.1.10, the factory preset of 10.1.1.10, or the IP address
configured while performing
Password dialog box is displayed, as shown in
Figure 34

Enter Network Password dialog box

ports, page 68
parameters, page 71
information, page 74
recipients, page 76
CLI, page 77
rights, page 78
"Configure network information" on page 74. The Enter Network
Figure 34.
Edge Switch 2/24 installation guide 67