HCD-C770/C990
Ver 1.5
4-3.
HOW TO INSTALL THE GEAR (MODE 2)
1 Align the mark on the rotary encoder (S701) with the projection of the assy.
2 Check that the cam (BU U/D) can not be rotated in the direction of arrow.
3 Install the gear (mode 2).
rotary encoder
(S701)
4-4.
HOW TO INSTALL THE GEAR (MODE CAM)
cam (gear)
20
gear
(mode 2)
mark
projection
– bottom view • front –
1 Slide the shaft in the direction of arrow.
2 Align mark A on the gear (mode cam) with mark B on the slider (mode cam) assy,
then install the gear (mode cam).
3 Check that mark C on the gear (mode cam) is in alignment with mark D on the cam (gear).
mark A
gear (mode cam)
mark D
– bottom view • front –
cam (BU U/D)
chassis
shaft
slider (mode cam) assy
mark B
mark C