Assembly Instructions - Kärcher HDS 3.9/30 Pe Cage Operator's Manual

High
Pressure
Hose
98000800-3
STEP 1: Attach the high pressure
hose to the spray gun by threading
twist connect onto spray gun inlet.
Pump
Discharge
98000800-6
STEP 4: Connect the high pressure
hose to the pump discharge fitting.
Thread twist connect to discharge
fitting by turning clockwise.
Due to Federal Regulations concerning shipment of corrosive chemicals,
batteries are not shipped with this machine.
Local purchase of battery will be the responsibility of the owner. Automotive
type 12 Volt Group 24 battery is recommended for placement within the
weather resistant box. Follow safety and installation instructions furnished
with the battery.
Red Cable is attached to battery (+) positive terminal, black cable is
Black - Negative
Terminal
Red + Positive
Terminal

ASSEMBLY INSTRUCTIONS

Spray
Gun
High Pressure
Nozzle
98000800-4
STEP 2: Remove wand end and first
place the o-ring followed by the high
pressure nozzle as shown. Replace
end of wand.
Cold
Water
Source
Garden
Hose
STEP 5: Connect garden hose to
the cold water source.
BATTERY INSTALLATION
connected to battery (-) negative
terminal.
9.800-080.0 - G • HDS 600-606
Wand
98000800-5
STEP 3: Remove shipping cap
and install oil dipstick (Depending
on type of shipping, dipstick may
already be installed). Check pump
oil level by using dipstick or observe
oil level in oil window (if equipped).
Use 30 wt. non detergent oil.
Water
Inlet
98000800-7
98000800-8
STEP 6: Check inlet filters, remove
debris, then connect the garden
hose to pump water inlet. CAUTION:
Do not run the pump without wa-
ter or pump damage will result.
DANGER/ POISON
SHIELD
EYES
NO
EXPLOSIVE
SPARKS
GASES
CAN CAUSE
FLAMES
BLINDNESS OR INJURY SMOKING
KEEP OUT OF THE REACH OF CHILDREN. DO NOT TIP. KEEP VENT CAPS TIGHT AND LEVEL.
Garden
Hose
Inlet
Filter
FLUSH EYES
IMMEDIATELY
WITH WATER
SULFURIC GET
ACID MEDICAL
CAN CAUSE HELP
BLINDNESS OR
FAST
SEVERE BURNS
7