Download Print this page

Black & Decker 200 WATT Instruction Manual page 2

Vehicle power system 200 watt power inverter with usb charging port
Hide thumbs

Advertisement

GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES
WARNING: Read all instructions before operating product. Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
• AVOID DANGEROUS ENVIRONMENTS Don't use appliances in damp or wet locations. Don't use appliances in the rain.
• KEEP CHILDREN AWAY. All visitors should be kept at a distance from work area.
• STORE IDLE APPLIANCES INDOORS. When not in use, appliances should be stored indoors in dry, and high or
locked-up place – out of reach of children.
• DON'T FORCE APPLIANCE. It will do the job better and with less likelihood of a risk of injury at the rate for which
it was designed.
• USE RIGHT APPLIANCE. Do not use the appliance for any job except that for which it is intended.
• DRESS PROPERLY. Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves and
substantial, non-skid footwear are recommended when working outdoors. Wear protective hair covering to contain
long hair.
• USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT. Use safety goggles or safety glasses with side shields,
complying with applicable safety standards and, when needed, a face shield. Also use face or dust mask if operation
is dusty. This applies to all persons in the work area. Also use a hard hat, hearing protection, gloves, safety shoes
and dust collection systems when specified or required. Safety glasses or the like are available at extra cost at your
local dealer or Black & Decker Service Center.
• DON'T ABUSE CORD. Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord from
heat, oil, and sharp edges.
• DON'T OVERREACH. Keep proper footing and balance at all times.
• DISCONNECT APPLIANCES. Disconnect the appliance from the power supply when not in use, before servicing,
and when changing accessories such as blades and the like.
• AVOID UNINTENTIONAL STARTING. Don't carry plugged-in appliance with finger on switch. Be sure switch is off
when plugging in.
• PROPER COOLING is essential when operating the inverter. Do not place the unit near the vehicle's heat vent
or in direct sunlight.
• ELECTRICAL FAULT CIRCUIT INTERRUPTOR protection should be provided on the circuits or outlets to be used.
Receptacles are available having built in electrical fault circuit interruptor protection and may be used for this
measure of safety.
• USE OF ACCESSORIES AND ATTACHMENTS. The use of any accessory or
attachment not recommended for use with this appliance could be hazardous. Note: Refer to the accessory section
of this manual for further details.
• STAY ALERT. Watch what you are doing. Use common sense. Do not operate tool when you are tired.
• CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its
operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by
authorized service center. Do not use tool if switch does not turn it on and off.
• DO NOT OPERATE portable electric tools near flammable liquids or in gaseous or explosive atmospheres. Motors
in these tools normally spark, and the sparks might ignite fumes.
• OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension cords intended for use
outdoors and so marked.
Volts
120V
240V
Ampere Rating
More
Than
0 -
6 -
10 -
12 -
READ ALL INSTRUCTIONS
Minimum Gage for Cord Sets
0-25
(0-7,6m)
0-50
(0-15,2m) (15,2-30,4m)
Not more
Than
6
18
10
18
12
16
16
14
Total Length of Cord in Feet
26-50
51-100
(7,6-15,2m)
(15,2-30,4m)
51-100
101-200
(30,4-60,9m)
American Wire Gage
16
16
16
14
16
14
12
Not Recommended
1
101-150
(30,4-45,7m)
201-300
(60,9-91,4m)
14
12
12

Hide quick links:

Advertisement

loading

  Related Manuals for Black & Decker 200 WATT

This manual is also suitable for:

Pi200ab