Epson FX Series User Manual page 362

ESCape = CHR$(27), 42-43
format for commands, iv-v, 46-47, 57-58
listed by function, 283-286
listed by number, 271-281
See also specific modes or functions
ESCape "!". Master Select. See Master Select
ESCape "#". Accepts eighth bit as is from computer. See Bit, high order
ESCape "%" CHR$(n
characters
ESCape "&" CHR$(n)"s
defined characters
ESCape "*" CHR$(m)CHR$(n
m. See Graphics Mode
ESCape "-0". Turns Underline Mode off. See Underline Mode
ESCape "-1". Turns Underline Mode on. See Underline Mode
ESCape "/" CHR$(n). Selects channel n. See Tabs, vertical
ESCape "0". Sets line spacing to 1/8". See Line spacing
ESCape "1". Sets line spacing to 7/72". See Line spacing
ESCape "2". Sets line spacing to 1/6". See Line spacing
ESCape "3" CHR$(n). Sets line spacing to n/216". See Line spacing
ESCape "4". Turns Italic Mode on. See Italic Mode
ESCape "5". Turns Italic Mode off. See Italic Mode
ESCape "6". Enables printing of control codes 128-159. See User-defined
characters
ESCape "7". Returns codes 128-159 to control codes. See User-defined
characters
ESCape "8". Turns paper-out sensor off. See Paper-out sensor
ESCape "9". Turns paper-out sensor on. See Paper-out sensor
ESCape ":" CHR$(n
RAM area. See User-defined characters
ESCape "<". Turns on One-line Unidirectional Mode. See Unidirectional
Mode
ESCape "=". Sets high-order bit off. See Bit, high order
ESCape ">". Sets high-order bit on. See bit, high order
ESCape "?s" CHR$(n). Reassigns an alternate graphics code, s. See
Graphics; Graphics Mode.
ESCape "@". Reset Code. See Reset Code
ESCape "A" CHR$(n). Sets line spacing to n/72". See Line spacing
ESCape "B" CHR$(n
vertical
ESCape "C" CHR$(0)CHRS(n). Sets the form length in inches. See Forms
ESCape "C" CHR$(n). Sets the form length in lines. See Forms
ESCape "D" CHR$(n1) ... CHR$(n
Tabs, horizontal
ESCape "E". Turns Emphasized Mode on. See Emphasized Mode
ESCape "F". Turns Emphasized Mode off. See Emphasized Mode
ESCape "G". Turns Double-Strike Mode on. See Double-Strike Mode
ESCape "H". Turns Double-Strike Mode off. See Double-Strike Mode
ESCape "I0". Returns codes 0-31 to control codes. See User-defined
characters.
340
)CHR$(n ). Selects a character set. See User-defined
1 2
s ". Selects characters to be defined. See User-
1 2
)CHR$(n
1
)CHR$(n )CHR$(n
1 2
) ... CHR$(n )CHR$(0). Sets vertical tabs. See Tabs,
1 k
)CHR$(0). Sets horizontal tabs. See
k
). Selects Graphics Mode, density
2
). Copies ROM characters to the
3