4 Replacement Procedures
3.
Remove the system board after making sure that all connectors are removed from their
respective sockets.
Installing the System Board
To install the system board, follow the steps below and refer to the figures in the preceding
section.
1.
Seat the system board in the chassis. Take care to align all the ports and connectors in
their respective openings on the chassis.
2.
Replace the two M2.5x4 screws to secure the system board.
3.
Connect the DC power cable to the socket on the system board.
4-56
Figure 4-66
Removing the system board
[CONFIDENTIAL]
Satellite P200D/P205D Series Maintenance Manual
4.22 System Board