Toshiba SoundStrip SBX5065KU User Manual page 16

16
Subwoofer wireless connection
In order to use the subwoofer, you must pair it with the SoundStrip
1. Connect the power cord to a wall outlet.
2. Turn on the SoundStrip
3. Turn the ON/OFF switch on the back of subwoofer to the "on" position.
4. The SoundStrip and the subwoofer will automatically pair up. The pairing indicator located in
®
upper right corner of the rear panel will appear red when the wireless link is activated.
When the wireless link is deactivated, the SoundStrip
SUBWOOFER" on the front panel display. You can press and hold the
button on the remote control for 8 seconds in HDMI
and hold the WIRELESS LINK button of the subwoofer for approximately 5
seconds until the red indicator is flashes.
The SoundStrip
subwoofer link are active.
Playing back via Bluetooth
1. Press the INPUT button on the remote or using the speaker system controls to select Bluetooth
mode as indicated when the display "shows "BT".
Your pairing device must have the Bluetooth
2. Once the SoundStrip
SoundBar" on your device.
3. Enter the PIN code.
PIN code : 0000
4. When this unit successfully paired with your Bluetooth ® device, it will appear "CONNECTED".
5. Select the desired music and press the PLAY button on your device.
Disconnect Bluetooth
1. Press the INPUT button to select Bluetooth
shown "BT".
2. Select disconnect or unpaired menu on paired Bluetooth
The SoundStrip become able to pair with another Bluetooth
®
The SoundStrip
order to properly pair with another Bluetooth
For details, please refer to the user manual of your Bluetooth
SBX5065KU_IB_R6.indd 16
.
®
will show "PAIRED" when the SoundStrip
®
® enabled devices
is detected by your Bluetooth
®
® enabled device
must disconnect or unpaired from a previous paired device in
®
.
®
® feature turned on.
® enabled device, select the "Toshiba
® mode until the display on the SoundStrip
® enabled device.
® enabled device.
®
enabled device.
will show "NO
®
® -2 mode. And then, press
and the
®
®
®
device.
2013/7/3 10:01:09
®
is