Toshiba Satellite P500 Maintenance Manual page 211

Replacement Procedures
Installing the cover assembly
The following describes the procedure for installing the cover assembly.
1. Install the cover assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.5×2.0
• M2.5×6.5
• M2.5×8.0
• M2.5×4.0
4. Free the cable from cable-drain when through the antenna cable to PCB hole.
Satellite P500 and Satellite Pro500 Maintenance Manual (960-Q08)
FLAT BIND screw Back
FLAT BIND screw Back
FLAT BIND screw Back
FLAT BIND screw Back
x5
x11
x6
x3
4-39