Mitsubishi Electric Apricot LS series Owner's Handbook Manual page 54

6
Configuring the drive
HARD DISK UPGRADES
This chapter describes how to add a second hard disk to your
computer.
WARNING
Never carry out any work inside the computer with AC power
applied. Always shut down the computer and unplug all power cords
before removing the top cover.
Your computer can accommodate two E-IDE hard disk drives,
known as the master and slave drives. The first drive, which
contains the operating system, is always configured as the master.
The second drive must be configured as the slave.
Hard disk drives are normally configured as master or slave by using
jumpers on the drive itself. Configuration details vary from drive to
drive. Most drives are supplied with documentation describing how
to configure the drive. If you are uncertain about configuring the
drive consult your supplier.
EXAMPLE
The example drive shown below is configured as master or slave by
the position of a jumper on the rear of the drive.
SLAVE
MASTER
OWNER'S HANDBOOK 6/1