Charging; Operation - Silvercrest SAS 7.2 A2 Operating Instructions Manual

Charging

Note:
Check to ensure that the on/off switch 6 has been
slid back (to the position "0") before starting the
charging process.
• Place the hand vacuum cleaner from above into
the wall holder 3 so that the barrel plug 5 slips
into the socket on the hand vacuum cleaner.
The charge indicator lamp 7 glows red and the
charging process begins.
Important!
• When the hand vacuum again has enough ener-
gy to vacuum, the charge indicator lamp 7
glows green. This does not mean that the batte-
ries are fully charged. When the charge indica-
tor lamp 7 glows green, it means the batteries
are charged to about 80%.
• When the charging process is complete, which
may take 12 to 15 hours for completely dis-
charged batteries, the device switches over to a
trickle charge (maintenance function) automati-
cally. Nevertheless, in order to avoid possible
damage to the batteries, do not leave the appli-
ance permanently connected to the power
adapter 4.
• Reconnect the appliance with the power adap-
ter 4 when the suction power has become
noticeably weaker.
Note:
The hand vacuum cleaner can also be charged
directly via the power adapter 4. For this, remove
the barrel plug 5 with a slight twist from the wall
holder 3 and insert it into the socket on the hand
vacuum cleaner.

Operation

Warning!
The suction opening must always be open and
unblocked. Blockages lead to overheating and da-
mage to the motor.
Tips:
• Make certain that the dust filter 9 is always
inserted before using the appliance.
• As the maximum, suck up only as much liquid as
will fill the dirt container 0 to the MAX mark.
1. Take the hand vacuum cleaner from the wall hol-
der 3 or, if you do not use the wall holder 3,
remove the barrel plug 5 from the socket.
2. If required, place the appropriate nozzle into the
suction opening:
• the crevice nozzle 2, to clean narrow and
difficult to reach locations.
• the wet suction nozzle 1 to vacuum liquids up.
Note:
After you have vacuumed up liquids, immediately
clean the dirt container 0. Otherwise bacteria and
microbes could form in it! Ensure that the dust filter
9/the dust filter bag is completely dry before using
the appliance again.
3. To switch the appliance on, slide the on/off
switch 6 forwards.
4. When you have finished using it, slide the on/
off switch 6 to the rear.
Place the hand vacuum in the wall holder 3
and start the charging process when the vacuum
power has become noticeably weaker.
- 29 -