16-18 ELECTRICAL SYSTEM
Fuel Tank (see Fuel Tank Removal in the Fuel System
Open the clamp [A], and free the leads.
Disconnect the regulator/rectifier lead connector [B].
Regulator/Rectifier Bracket Bolts [A]
Regulator/Rectifier Nuts [B]
Replace the regulator/rectifier nuts [A] with new ones.
Torque - Regulator/Rectifier Nuts: 10 N·m (1.0 kgf·m, 89
Tighten the regulator/rectifier bracket bolts [D].
Run the regulator/rectifier lead according to the Cable,
Wire, and Hose Routing section in the Appendix chapter.
Connect the regulator/rectifier lead connector.
Install the fuel tank (see Fuel Tank Installation in the Fuel
System (DFI) chapter).
Regulator/Rectifier Output Voltage Inspection
Be sure the prepared battery is fully charged.