When installing the breather fitting [A], note the following.
Apply a non-permanent locking agent to the threads of
the breather fitting.
Torque - Breather Fitting: 15 N·m (1.5 kgf·m, 11 ft·lb)
Magneto Cover [A]
Magneto Cover Bolts [D]
Torque - Magneto Cover Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Run the magneto lead, breather hose and gear position
switch lead according to the Cable, Wire, and Hose Rout-
ing section in the Appendix chapter.
Connect the magneto lead connector.
Install the removed parts (see appropriate chapters).
Remove the magneto cover (see Magneto Cover Re-
Hold the flywheel steady with the rotor holder [A], and
remove the flywheel nut [B].
Special Tools - Grip [C]: 57001-1591
Rotor Holder: 57001-1730
Remove the rotor holder.
Install the flywheel puller [A] to the flywheel.
Install the rotor puller [B] to the flywheel puller.
Remove the flywheel from the crankshaft by turning in the
rotor puller and tapping the head of the puller lightly with
a hammer, while holding the puller body steady. There is
a woodruff key in the crankshaft tapered portion.
Special Tools - Rotor Puller, M16/M18/M20/M22 × 1.5: 57001
Flywheel Puller, M28 × 1.0: 57001-1471
Never strike the grab bar or the flywheel itself. Strik-
ing the bar can bond it. If the flywheel is struck, the
magnets may lose their magnetism.
ELECTRICAL SYSTEM 16-13