16-12 ELECTRICAL SYSTEM
Magneto Cover Removal
Drain the engine oil (see Engine Oil Change in the Peri-
odic Maintenance chapter).
Left Radiator Shroud (see Radiator Shroud Removal in
the Frame chapter)
Shift Pedal (see Shift Pedal Removal in the Crank-
Disconnect the magneto lead connector [A] from the main
Remove the band [A].
Open the clamps [B] then free the breather hose [C] and
gear position switch lead [D].
Magneto Cover Bolts [E]
Magneto Cover [F]
Magneto Cover Installation
Replace the gasket [A] with a new one and install it.
Be sure to install the dowel pins [B].
Using a high flash-point solvent, clean off any oil or dirt
that may be on the silicone sealant coating area. Dry
them with a clean cloth.
Apply silicone sealant to the area [A] to the magneto lead
Sealant - Liquid Gasket, TB1211F: 92104-0004
When installing the balancer shaft oil seal [A], note the
Replace the balancer shaft oil seal with a new one.
Press the balancer shaft oil seal so that the magneto
cover end [B] is flushed as shown in the figure.
Special Tool - Bearing Driver Set: 57001-1129
Apply grease to the oil seal lips.