Remove the handlebar pad.
Remove the handlebar clamp bolts [A], handlebar clamps
[B] and handlebar [C].
Check the handlebar for damage or cracks.
If the handlebar is damage or cracks, replace it with a new
Handlebar Holder Nuts [A]
Flat Washers [B]
Round Washers [C]
Handlebar Holders [D]
Select the handlebar position and install the upper and
lower dampers [A] into the hole [B] of the steering stem
head [C] so that the flat surface [D] of dampers fit the flat
surface [E] of the steering stem head hole.
Install the round washer [A] and handlebar holder [B] in
the suitable direction.
Install the round washer so that the round part fits on the
Put the handlebar [A] on the handlebar holders [B].
Temporarily install the handlebar clamps [C] and tighten
the handlebar clamp bolts [D].
Replace the handlebar holder nuts [E] with new ones.
Install the round washers [F], flat washers [G], and han-
dlebar holder nuts .
Install the round washers so that the round part fits under
Torque - Handlebar Holder Nuts: 34 N·m (3.5 kgf·m, 25 ft·lb)
Install the handlebar (see Handlebar Installation).