Tie-Rod, Rocker Arm
Install the needle bearings [A] [B], oil seals [C] and grease
seals [D] so that their positions are as shown in the figure.
The other side is also the same procedures.
Right Side [F]
Left Side [G]
Rear Shock Absorber [H]
Rocker Arm [J]
Deep Groove [K]
Needle Bearing Inspection
Do not remove the bearings for inspection. Re-
moval may damage them.
Inspect the needle bearings installed in the tie-rod and
The needle bearing normally wear very little, and wear
is difficult to measure. Instead of measuring, visually in-
spect the bearings for abrasion, discoloration, or other
If there is any doubt as to the condition of either needle
bearing, replace the bearing and sleeve as a set.