Tie-Rod, Rocker Arm
Rocker Arm Installation
Replace with new ones:
Rear Shock Absorber Mounting Nut (Lower)
Rocker Arm Pivot Nut
Tie-Rod Mounting Nut
Apply plenty of grease to the needle bearings and grease
Check that collars are in place on the rocker arm.
Install the rocker arm.
Apply grease to the seating surface of the rocker arm pivot
nut and tie-rod mounting nut.
Torque - Rear Shock Absorber Mounting Nut (Lower): 34
N·m (3.5 kgf·m, 25 ft·lb)
Rocker Arm Pivot Nut: 59 N·m (6.0 kgf·m, 44 ft·lb)
Tie-Rod Mounting Nut: 59 N·m (6.0 kgf·m, 44 ft·lb)
Tie-Rod and Rocker Arm Bearing Removal
Tie-Rod (see Tie-Rod Removal)
Rocker Arm (see Rocker Arm Removal)
Oil Seals [C]
Grease Seals [D]
Remove the needle bearing [E], using the bearing re-
mover head and bearing remover shaft.
Remove the needle bearings [F], using the oil seal & bear-
Special Tools - Bearing Remover Head,
Bearing Remover Shaft, 13: 57001-1377
Oil Seal & Bearing Remover: 57001-1058
Tie-Rod and Rocker Arm Bearing Installation
Replace the needle bearings, oil seals and grease seals
with new ones.
Apply plenty of grease to the oil seals, grease seals and
Install the bearings so that the marked side faces out.
Install the oil seals so that the deep groove side faces
Install the grease seals so that the groove side faces