Remove the screws [A].
Remove the chain slipper [B] from the swingarm.
Apply plenty of grease to the inside of the needle bear-
ings, sleeves, and grease seals.
Apply a non-permanent locking agent to the chain slipper
Install the chain slipper, and tighten the screws.
Replace with new ones:
Swingarm Pivot Shaft Nut
Rocker Arm Pivot Nut
Apply grease to the seating surface of the rocker arm pivot
Install the swingarm.
Torque - Swingarm Pivot Shaft Nut: 98 N·m (10 kgf·m, 72
Rocker Arm Pivot Nut: 59 N·m (6.0 kgf·m, 44 ft·lb)
Install the removed parts (see appropriate chapters).
Swingarm Bearing Removal
Swingarm (see Swingarm Removal)
Grease Seals [B]
Needle Bearings [D]
Remove the needle bearings [E] using the oil seal & bear-
Special Tool - Oil Seal & Bearing Remover: 57001-1058
Swingarm Bearing Installation
Replace the needle bearings and grease seals with new
Apply plenty of grease to the grease seals and needle
bearings [A] [B].
Install the needle bearings so that the manufacturer's
marks face out.
Install the grease seals so that the deep groove side of
the rip to the needle bearings.
Special Tool - Bearing Driver Set: 57001-1129
Install the needle bearings, grease seals [C], sleeve [D]
and collar [E] position as shown in the figure.
The installation procedure is the same as the counter