Remove the collars [A] with caps [B] on both sides.
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks under the wheel so the disc does not
touch the ground.
Insert a wood wedge between the brake pads.
This prevents them from being moved out of their proper
position, should the brake pedal be squeezed acciden-
Rear Wheel Installation
Fit the groove [A] of the caliper holder and swingarm rib
Apply high-temperature grease to the oil seal lips.
Install the caps and collars to the hub on both sides.
Fit the projection [A] and groove [B].
Install the rear wheel.
Install the chain adjusters on the swingarm as shown in
Adjuster [A] (Left Side)
Flat Adjuster [B] (Right Side)
Insert the axle from left side, and temporarily tighten the
Install the drive chain (see Drive Chain Installation in the
Final Drive chapter).
Torque - Rear Axle Nut: 108 N·m (11.0 kgf·m, 79.7 ft·lb)