Balancer Drive Gear [B]
Special Tool - Outside Circlip Pliers: 57001-144
Remove the crankcase bolts [A].
Insert a suitable tool to the pry point [A], and split the
If the crankcase cannot be split easily, split the crankcase
according to the following procedures.
Install the jig [A] between the crankshaft flywheels.
Special Tool - Crankshaft Jig: 57001-1174
Attach the crankcase splitting tool [B] to the left crankcase
Special Tool - Crankcase Splitting Tool Assembly: 57001
Tighten the center bolt of the crankcase splitting tool to
split the crankcase halves.
Oil Screen (Feed) [A] (see Oil Screen (Feed) Removal
in the Engine Lubrication System chapter)
Shift Rods [B] (see Transmission Shaft Removal)
Shift Forks [C] (see Transmission Shaft Removal)
Shift Drum [D] (see Transmission Shaft Removal)
Transmission Shafts [E] (see Transmission Shaft Re-
Crankshaft [F] (see Crankshaft Removal)