Clutch Cover and Right Engine Cover
Kick Pedal (see Kick Pedal Removal in the Crank-
Rear Master Cylinder Mounting Bolts [A]
Brake Pedal Bolt [B]
Brake Pedal Return Spring [C]
Right Engine Guard [B]
Water Pump Cover (see Water Pump Cover Removal in
the Cooling System chapter)
Clutch Cover Bolt [A]
Oil Filter Cap Bolt [B]
Right Engine Cover Bolts [C]
Right Engine Cover [D]
Right Engine Cover Installation
Install the dowel pins [A].
Replace the O-rings [B] with new ones.
Replace the right engine cover gasket [C] with a new one.
Wrap the spline [D] of the kick shaft with the vinyl tape to
Apply grease to the O-rings and install them to the
Install the lower O-ring so that the tapered side facing
Apply a grease to the kick shaft oil seal lip.
When installing the cover does not go well, the cover is
installed according to the following procedures.
Install the cover while turning the impeller [A].
Torque - Right Engine Cover Bolts: 9.8 N·m (1.0 kgf·m, 87
Clutch Cover Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Oil Filter Cap Bolt: 9.8 N·m (1.0 kgf·m, 87 in·lb)