Technical Information - DFI Setting Data Selection
The DFI setting can be easily selected among three op-
tions to suit various track conditions without using the KX FI
The setting can be switched by changing the connector
[A] on the right side of the steering stem.
Change the connector with the engine stopped.
Remove the connector upward [A] from the bracket while
pushing the connector stopper [B].
Select the connector suitable for the track condition and
install it to the bracket.
The ignition timing and fuel injection are set to suit each
track condition in the DFI setting.
The DFI setting at start-up is maintained until the engine
stops. If the connector is changed during idling, the DFI
setting does not change.
The DFI setting is fixed to the standard track condi-
tion when the connector is removed with the engine
stopped. Always have one of the three connectors at-
tached when riding to prevent mud and dust from accu-
mulating in the connector terminal.
The DFI setting can be changed to suit user's prefer-
ence using the KX FI calibration kit.
When the connector is not attached, the KX FI calibra-
tion kit cannot change the DFI setting.
GENERAL INFORMATION 1-11