APRILIA RSV 1000 R Factory Use And Maintenance Book page 72

Torque wrench setting for wheel
spindle clamp bolts: 22 Nm (2.2 kgm)
; 12 Nm (1.2 kgm)
◆
Slacken but do not remove the two
wheel spindle clamp bolts (4) on the right
side.
◆
Slacken but do not remove the two
wheel spindle clamp bolts (5) on the left
side.
NOTE
Note the direction of the spacer
(6) placed on the right side to refit it
correctly on assembly.
NOTE
Lift the wheel slightly to facilitate
spindle removal.
◆
Push on the threaded end of the wheel
spindle (7) carefully. Tap with a plastic
mallet if needed.
◆
Hold the front wheel and withdraw the
wheel spindle (7) manually.
◆
Ease the wheel off in a forward motion.
CAUTION
The spacer (6) should still be sitting in
the wheel hub. If it slips off, refit it
correctly (see REFITTING THE WHEEL).
use and maintenance RSV 1000 R - RSV 1000 R FACTORY
72
REFITTING THE WHEEL
◆
Smear a light coat of grease over the
.
total length of the wheel spindle (7), see
page 117 (LUBRICANT CHART).
Use great care when refitting the wheel
to avoid damaging the brake lines,
brake disks and brake pads.
NOTE
required when the spacer (6) has slipped
out of place.
◆
Position the spacer (6) to the wheel with
the larger diameter facing out.
The arrow mark on the hub points in the
direction of rotation.
Make sure to refit the wheel in the
correct direction. The arrow must be on
the left side of the vehicle.
◆
Place the wheel between the fork legs
and over the support (1).
CAUTION
The next procedure is only
CAUTION
WARNING
Do not attempt to align the holes by
putting your fingers into the holes.
◆
Move the wheel until the wheel hub bore
aligns with the holes in the fork.
◆
Slide the wheel spindle (7) fully home
from the left side.
NOTE
Make sure the wheel spindle (7)
is fully in the hub.
◆
Fit the washer (3) and screw the wheel
hub nut (2) finger-tight.
NOTE
Next, you will have to temporarily
fit the two wheel spindle clamp bolts (5) on
the left side. It is not necessary to tighten
them to the final torque.