Your Location; Auto Clock Adj/Auto Area Adj - Sony Handycam How To Use Manual

movie or photo will be displayed at the center
of the map.

YOUR LOCATION

You can display the current location on a
map.
Set the GPS switch to ON so that your
camcorder can acquire the current location
information.
Touch ( YOUR LOCATION) on the
recording screen.
The current location is displayed and
marked at the center of the LCD screen.
If you touch a certain point on the screen,
the map shows the area with that point at
the center.
Touch (your location) at the bottom
left of the LCD screen to move the current
location back to the center.
To close the map screen
Touch .

Notes
The map always displays the north at the top.

Tips

You can change the scale using the zoom lever

or zoom buttons (W: larger, T: smaller).
Your camcorder acquires the current location

information every 10 seconds. The displays
of the center marker, etc., appear differently
according to the status of the current inquiry.
When your camcorder cannot acquire the

current location information, the center marker
turns gray and the map shows the last location
acquired.
If you hold a certain point, the map keeps

scrolling.
You can also display the current location by

(HOME) 
touching
[ YOUR LOCATION].

AUTO CLOCK ADJ/AUTO AREA ADJ

Your camcorder can maintain accurate
time and compensate for time difference
automatically, by acquiring time and
location information from GPS.
 (HOME) 
Touch
(SETTINGS)  [CLOCK/ LANG]
 [AUTO CLOCK ADJ]/[AUTO
AREA ADJ].
 Touch a desired setting 

.

Notes
You must set the date and time on your

camcorder before using your camcorder.
There may be discrepancies of a few seconds

even if [AUTO CLOCK ADJ] is activated.
The clock is adjusted automatically by

[AUTO CLOCK ADJ] when you turn off your
camcorder if the camcorder is receiving a GPS
signal while it is being used. The clock is not
adjusted until the camcorder is turned off. Also,
the clock is not adjusted unless the camcorder
is receiving a GPS signal, even if the GPS switch
is set to ON.
The [AUTO AREA ADJ] function automatically

compensates for a time difference when it
detects a time differences with the current area.
(OTHERS) 

GB