Front Course Loc Approach Using Hsi - Honeywell KAP 140 Manual

Single Axis Operation

Front Course LOC Approach Using HSI

D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
GS GS
ı
G
KAP 140
AP HDG NAV APR REV
1. Continuing the maneuver on page 40, APR cou-
HDG
pling occurs ( annunciation changes to
APR
). The autopilot will capture the localizer
and the CDI course index will center.
44
KAP 140 AUTOPILOT SYSTEM
D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
GS GS
ı
G
KAP 140
AP HDG NAV APR REV
2. The autopilot is following the localizer. The
autopilot will make bank changes as necessary
to maintain localizer.
Rev. 1
Apr/02
D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
GS GS
ı
G
KAP 140
AP HDG NAV APR REV
3. At the missed approach point, the pilot disen-
gages the autopilot with the button on the con-
trol wheel. This cancels all operating modes.
Rev. 1
KAP 140 AUTOPILOT SYSTEM
Apr/02
Single Axis Operation
D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
GS GS
ı
G
KAP 140
AP HDG NAV APR REV
4. The pilot initiates the missed approach and sta-
bilizes the aircraft in the climb. The heading
bug is set to the missed approach heading of
HDG
090°. By depressing the button on the
KAP 140, the autopilot engages into the head-
ing mode, commencing a right turn to a head-
ing of 090°.
AP
Note: Press and hold the button for 0.25
seconds to engage the autopilot (applicable
only to software version 03/01 and later).
45