Download Print this page

Specific Safety Rules - Black & Decker BDCF20 Instruction Manual

20v max led flashlight
Hide thumbs

Advertisement

the correct power tool for your
application. The correct power tool will
do the job better and safer at the rate
for which it was designed.
b) do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot
be controlled with the switch is
dangerous and must be repaired.
c) disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of
the reach of children and do not
allow persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Maintain power tools. check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f) keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g) use the power tool, accessories
and tool bits, etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed.
Use of the power tool for operations
different from those intended could
result in a hazardous situation.
5) BAtteRy tool uSe ANd cARe
a) Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire
when used with another battery pack.
b) use power tools only with
specifically designated battery
packs. Use of any other battery packs
may create a risk of injury and fire.
c) When battery pack is not in use,
keep it away from other metal
objects like paper clips, coins, keys,
nails, screws, or other small metal
objects that can make a connection
from one terminal to another.
Shorting the battery terminals together
may cause burns or a fire.
d) under abusive conditions,
liquid may be ejected from the
battery, avoid contact. If contact
accidentally occurs, flush with
water. If liquid contacts eyes,
additionally seek medical help.
Liquid ejected from the battery may
cause irritation or burns.
6) SeRvIce
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power
tool is maintained.

SPecIfIc SAfety RuleS

WARNING:
APPlIANceS, BASIc PRecAutIoNS
SHould AlWAyS Be folloWed,
INcludING tHe folloWING:
• Read all the instRuctions
BefoRe uSING tHe APPlIANce.
• To reduce the risk of injury, close
supervision is necessary when an
appliance is used near children.
• Only use attachments recommended or
sold by the manufacturer.
• To reduce the risk of electrical shock, do
not put light in water or other liquid. Do
not place or store appliance where it
can fall or be pulled into a tub or sink.
• Use only the charger supplied by the
manufacturer to recharge.
• During or immediately after use, don't lay
light flat on lens surface.
• Replace broken bulb in a well ventilated area.
• Don't touch lens surface when bulb is lit
or immediately after use.
• Handle light with care around any
flammable surface.
• Do not expose light or charger to wet
or damp areas. Do not expose light or
charger to rain or snow.
• Do not wash light or charger with water or
allow water to get inside light or charger.
• While light is in use, do not cover with
cloth or other flammable materials due to
increased risk of fire.
• Do not operate without lens cover
assembly attached.
• For household use only.
WARNING:
operate flashlight or charger near
flammable liquids or in gaseous or
explosive atmospheres. Internal sparks
may ignite fumes causing personal injury.
WARNING:
during use. To reduce the risk of burns,
do not touch hot lens. To reduce the risk
of fire, keep away from combustible
materials while in operation.
cAutIoN:
tool on its side on a stable surface
where it will not cause a tripping or
falling hazard. Some tools with large
battery packs will stand upright on the battery
pack but may be easily knocked over.
3
WHeN uSING electRIc
Burn hazard. Do not
the lens gets very hot
When not in use, place

Advertisement

loading

  Also See for Black & Decker BDCF20