Switch Action - Makita 2704 Instruction Manual

Adjusting positive stops
1
006156
(A)
90
45
45
90
(B)
006157
The tool is equipped with positive stops at 90° and 45° to
the table surface. To check and adjust the positive stops,
proceed as follows:
Move the handwheel as far as possible by turning it.
Place a triangular rule on the table and check to see if
the blade is at 90° or 45° to the table surface. If the blade
is at an angle shown in Fig. A, turn the adjusting screws
clockwise; if it is at an angle shown in Fig. B, turn the
adjusting screws counterclockwise to adjust the positive
stops.
After adjusting the positive stops, set the blade at 90° to
the table surface. Then adjust the arrow pointer so that
its right edge is aligned to the 0° graduation.
006158
1. 90 ﾟ Adjusting
screw
2. 45 ﾟ Adjusting
screw
2
1. Arrow pointer
1

Switch action

ON
OFF
006217
CAUTION:
Before plugging in the tool, always be sure that the
•
tool is switched off.
To start the tool, raise the switch lever. To stop it, lower
the switch lever.
The hinged switch lever plate can be locked by passing
padlock through the hasp on the left hand side.
006216
Sub table (R)
1
006149
006150
This tool is provided with the sub table (R) on the right
side of the main table. To use the sub table (R), raise
both levers on the front right side, pull out the table (R)
6
1. Switch
1
1. Padlock
1
1. Lever
1. Sub table (R)
1