FRONT WHEEL REMOVAL
1. Raise the front wheel off the ground
by
placing a support block under the
engine.
2. Remove
the speedometer cable
set
screw
(I)
and disconnect the speedo-
meter cable (2).
3. Remove the left caliper assembly by
loosening the caliper bolts (3).
4. Remove tpe left caliper bracket (4) by
removing the mounting bolts (5).
•
(I)
Speedometer cable set screw (3) Caliper bolts
(2) Speedometer cable
52
CAUTION:
'*
Support the caliper assembly so that it
does not hang from the brake hose. Do
not twist the brake hose.
*
A void getting grease, oil or dirt on the
disc or pad surfaces, because such
contamination can cause poor brake
performance or rapid pad wear after
reassembly.
5. Remove the front axle holder nuts (6)
and axle holders (7).
6. Remove the wheel.
(4) Caliper bracket (6) Axle holder nuts
(5) Mounting bolts (7) Axle holders