Getting Started
Physical Installation
The EdgeMarc 4500 is designed for desktop, rack or wall-mount installation. Observe the
following guidelines when installing the system:
Always verify that the AC cord is disconnected from a power source prior to installation.
•
Ensure that the installation site has adequate air circulation and meets the minimum
•
operating conditions for the system as specified in Specifications section of this document
Required Tools and Materials
If the unit is to be mounted on the wall then:
•
1 Flat or Philips screw driver
─
2 round or flat head Philips or slotted screws – 1 ½ inch long
─
2 hollow wall anchors
─
If the unit will be mounted in a shelf:
•
1 Flat or Philips screw driver
─
Ethernet cables to connect the LAN ports to LAN switches or to individual IP phones. They
•
can also be used to connect the Ethernet WAN port to a WAN router, a Cable Modem or a
DSL Modem.
Desktop Installation
1. Remove the EdgeMarc 4500 and accessories from the shipping container.
2. Place the EdgeMarc 4500 on a flat, dry surface such as a desktop, shelf or tray.
2
7