Drain Facility; Location Considerations; Alcove Or Closet Installation - Maytag MAH6700AW Series Service

27” front load washer
Table of Contents

Advertisement

To Avoid The Possibility Of W ater Damage:
• Have Water Faucets Easily Accessible
• Turn Off Faucets When Washer Is Not In Use.

DRAIN FACILITY

Recommended height of the standpipe is 18". The drain hose must be routed through the drain hose clip
to the standpipe. Standpipe must be large enough to accept the outside diameter of the drain hose. The
drain hose is attached at the factory.
FLOORING
For best performance the washer must be installed on a solidly constructed floor. Wood floors may need
to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting and soft tile surfaces
are contributing factors in vibration and/or tendency for a washer to move slightly during the spin cycle.
Never install the washer on a platform or weakly supported structure.

LOCATION CONSIDERATIONS

It is recommended the washer never be installed in areas where water may freeze since the washer will
always maintain some water in the water valve, pump and hose areas. This can cause damage to belts,
pump, hoses and other components. Operating temperature should be above 60°F .

ALCOVE OR CLOSET INSTALLATION

MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INST ALLATIONS:
Sides – 0 in / 0 mm
T op – 17 in / 432 mm
The closet front must have a total unobstructed air opening of 72 in
and dryer are installed together. A louvered door with equivalent air opening is acceptable. Washer alone
does not require specific air opening.
©2006 Maytag Services
Rear – 2-3/8 in / 60 mm
Closet Front – 2 in / 51 mm
16026186
2
. / 465 cm
2
minimum, if both washer
A-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents