Vibration/Walking/Noise; Leaving Marks On Floor; Rubber Feet; Additive Cups Full Of Water - Maytag MAH6700AW Series Service

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.

Vibration/Walking/Noise

•
Check for proper load size and distribution.
•
Check for proper installation (See Appendix A).
•
Verify unit has new motion sensor / control board.
•
Check vent flappers for foam present on flapper.
•
Check for loose pump to bracket screws.
•
Check for stripped pump mounting bolts.
•
Check location of top suspension springs.
•
Check console for broken plastic locating tabs,
check for front panel noise - add foam as needed.
•
Check if debris is present in pump causing noise.
•
Check dampers / inserts-front/grey,rear/green.
•
Clean floor and check condition of rubber feet.
•
Do Paper Test - Place paper strips under front
feet of washer, pull them out while in Quick Spin
Test at highest rpm. Adjust feet to hold paper.
Rubber Feet Leaving Marks on Floor
•
Use a pencil eraser to remove mark.
•
Walk washer into location, do not drag.

Additive Cups Full of Water

•
A small amount of water in cups is normal.
•
Remove and wash dispenser tray, removable cup,
and rinse cap.
•
Level washer.

Buttons do not Respond

•
Option and Function buttons respond differently
according to each cycle.
•
Child Lock feature has been selected. To disable
feature press and hold Wash/Rinse Temp and
Spin Speed simultaneously until a beep is
heard.
•
When display shows "00", only the Power Off
button will function. Press Power Off and make
new cycle selections.

Consumer Information Codes

If the consumer observes codes on display, see table
below.
LED Description
Display
The water level fails to
drop below the Low
Water level reset within
nd
15 minutes, before a
spin begins.
Door failed to unlock
LO
after 3 attempts.
Continuous fill of 12
minutes. Total fill of 14
nF
minutes.
12
!
WARNING
LED
Display
FL
LE
OE
E2
dc
od
dL
dS
bE
tE
E3
Diagnostic
Sr
code
3E
1
2E
2E
2
3
16026186
Description
Door failed to lock after 3
attempts.
Water sensor level fault.
A fault is detected in the
water level sensor. Data
(frequency) shows the
water level is at or above
the overflow level.
A key is sensed to be
pressed more than 30
seconds, the key will be
assumed to be stuck.
Never exceeded 400 rpm
due to an unbalanced
load.
The door has not been
opened after two complete
wash cycles. Door switch
was not seen open since
the last two final spins.
Open door lock switch with
motor running.
Door switch is read as
open and the door locked
switch is read as locked.
Motor tach signal exists
without motor running.
Abnormal high/low temp or
ohm resistance seen.
Machine control is
attempting to drive the
motor but is not seeing
any tach response. Visual
check shows motor is not
moving. (Locked, Hall
Sensor fault).
System Relay failure.
Over Current is detected.
Motor won't turn.
Voltage for motor control
bus is over specified limit.
Voltage for motor control
bus is under specified
limit.
©2006 Maytag Services
Diagnostic
code
4
8
E
15
10
17
18
22
25
29
2E
34
3E
91
92