^ . Unit Function Setting by the Remote Controller (for Mr. SLIM)
Perform the following settings only to change the functions for Mr. Slim series.
(This setting is not possible with the City-Multi series.)
Each function can be set according to necessity using the remote controller. The setting of function for each unit can only be
done by the remote controller. Select available function from the table. (For details regarding initial settings and operation modes
of each unit, refer to the unit installation manual.)
() Itemised functions of the entire refrigerant system (select unit number 00)
Function
OFF
Power failure
automatic recovery
ON
Average data from each indoor unit
Indoor temperature
Data from the indoor unit with remote controller
detecting *
Data from main remote controller
Not supported
Supported (indoor unit does not intake outdoor air
LOSSNAY
through LOSSNAY)
connectivity
Supported (indoor unit intakes outdoor air through
LOSSNAY)
240V
Power voltage
220V, 230V
Auto operating mode
Auto energy-saving operation ON
*2
Auto energy-saving operation OFF
Frost prevention
2:(Normal)
temperature
3:
Standard
Defrosting control
For high humidity
70% (RP35, 50) / 80% (RP60-40, HRP)
Refrigerant leakage
setting(%) *3
50% (RP35, 50) / 60% (RP60-40, HRP)
*1. Can be set only when a wired remote controller is used. This function cannot be set for floor type models.
When using 2 remote controllers (two-remote controller operation), the remote controller with built-in sensor must be set as a main remote
controller.
*2. Can be set only when the outdoor unit is an inverter type.
*3. Can be set only when the outdoor unit is (H)RP type.
Meaning of "Function setting"
Mode02 : indoor temperature detecting
No indoor temperature(ta)
No. Average data of the
sensor on all the
indoor units
No.2 The data of the sen-
sor on the indoor unit
that connected with
remote controller
No.3 The data of the sen-
sor on main remote
controller.
38
Settings
OUTDOOR
INDOOR
INDOOR
REMOTE
REMOTE
(MAIN)
(SUB)
Intial
ta=(A+B)/2
setting
ta=A
ta=C
Mode No. Setting No.
2
3
4
5
5
7
2
OUTDOOR
INDOOR
INDOOR
REMOTE
REMOTE
(MAIN)
(SUB)
ta=(A+B)/2
ta=A
ta=B
ta=A
ta=C
ta=C
Check
Remarks
2
2
3
2
3
2
2
2
2
2
OUTDOOR
OUTDOOR
INDOOR
INDOOR
REMOTE
REMOTE
REMOTE
(MAIN)
(SUB)
(MAIN)
ta=A
ta=A
ta=C