Installing Or Removing Sfps - HP 1810-8 Installation And Getting Started Manual

N o t e
C a u t i o n
W A R N I N G

6. Installing or Removing SFPs

You can install or remove an SFP transceiver from an SFP slot without having
to power off the switch.
The SFP ports operate only at full duplex. Half duplex operation is not
■
supported.
■ Ensure the network cable is NOT connected when you install or remove
an SFP.
Use only supported genuine HP SFPs with your switch. Non-HP SFPs are not
supported, and their use may result in product malfunction. Should you
require additional HP SFPs, contact your HP Sales and Service Office or
authorized dealer. For information on supported SFPs and mini-GBICs, see
"Network Ports" on page
Installing the SFPs:
Remove the protective cover and retain it for later use. Hold the SFP by its
sides and gently insert it into either of the slots on the switch until the SFP
clicks into place.
The HP SFPs are Class 1 laser devices. Avoid direct eye exposure to
the beam coming from the transmit port.
1-3.
Installing the Switch
Installation Procedure
2-15