3.2.12 Multiple Copies - Mitsubishi Electric FR-PU07 Instruction Manual

Operation Procedures for Functions

3.2.12 Multiple copies

(1) Copying the parameter settings
Parameter settings of an inverter can be read. The settings of maximum three inverters can be stored in
the FR-PU07. You can also copy the stored parameter settings to another inverter of the same series.
Confirm for setting
· Is the PU operation mode selected? → If not, press
· Is the inverter stopped? → If it is running, press
· Is the Pr. 77 setting of the copy destination inverter correct? → Set "0 or 2" in Pr. 77.
· Is the inverter of the copy destination the same series as that of the copy source? → Select the inverter of the same series.
FR-A720-0.4K → FR-A720-0.75K
Example:
× FR-A720-0.4K → FR-F720-0.75K
CAUTION
Turning power OFF during parameter copy (read, write) as below, processing is not completely ended.
Perform parameter copy again.
· Turn OFF the inverter power.
· The FR-PU07BB (battery mode) power is OFF or battery exhaustion.
· Remove the FR-PU07 from the inverter.
· Pull out the PU cable.
76
to select the PU operation mode.
to stop it.
Parameters can be copied only to the
same series inverters.