Installation and connection
Connection to the hot water supply
To keep electricity consumption costs
down this machine can be connected
to a (ring) piped hot water supply. The
maximum temperature must not exceed
70°C.
It is not economical to run it from an
individual hot water supply if it is not in
continuous use, as the water in the
supply pipes cools down and more
energy would be required to reheat the
water.
For hot water connection the same
conditions apply as for cold water
connection.
The inlet hose with the red stripes (hot
water hose) is connected to the
stopcock.
For operational reasons the machine
must not be connected to hot water
only.
If the machine is not connected to a hot
water supply, the water settings for the
main wash , pre-wash and rinses must
be re-programmed.
^ Go to Settings menu / Supervisor level
and select the Cold option for each of
the above. The Settings / Supervisor
level needs to be activated by a
Miele service technician.
The programme durations may be
longer.
50
^ Unscrew the inlet hose (hot water -
red stripes)
^ Plug the inlet connection with the cap
supplied.
Connection to a very hot water
supply
It is possible to connect the machine to
a very hot water supply, 70°C to a
maximum of 85°C. A special inlet hose
is required. The machine must also be
reprogrammed by a Miele service
technician or Miele authorised service
dealer.