Brother KE-430D Instruction Manual page 63

Feed mechanism-related errors
Code
X feed motor home position cannot be detected. Problem with X feed motor or poor X home position sensor
connection.
E200
Turn off the power, and then check that connector P10 on the PMD P.C. board and connector P2 on the main
P.C. board are properly connected.
X feed motor stopped abnormally.
E201
Turn off the power and check that there is no problem with the X feed direction.
Problem with X feed motor or Y feed motor home position adjustment data.
E202
Re-adjust the home position.
X feed motor stopped abnormally during sewing.
E204
Turn off the power and check that there is no problem with the X feed direction.
X feed motor stopped abnormally while moving to the sewing start position.
E205
Turn off the power and check that there is no problem with the X feed direction.
X feed motor stopped abnormally during test feeding.
E206
Turn off the power and check that there is no problem with the X feed direction.
Y feed motor home position cannot be detected. Problem with Y feed motor or poor Y home position sensor
connection.
E210
Turn off the power, and then check that connector P8 on the PMD P.C. board and connector P3 on the main P.C.
board are properly connected.
Y feed motor stopped abnormally.
E211
Turn off the power and check that there is no problem with the Y feed direction.
Y feed motor stopped abnormally during sewing.
E214
Turn off the power and check that there is no problem with the Y feed direction.
Y feed motor stopped abnormally while moving to the sewing start position.
E215
Turn off the power and check that there is no problem with the Y feed direction.
Y feed motor stopped abnormally during test feeding.
E216
Turn off the power and check that there is no problem with the Y feed direction.
Work clamp-related errors
Code
Work clamp home position cannot be detected. Problem with work clamp motor or poor work clamp home
position sensor connection.
E300
Turn off the power, and then check that connector P3 on the PMD P.C. board and connector P4 on the main P.C.
board are properly connected.
Work clamp raised or lowered position cannot be detected.
E301
Turn off the power, and check that there is no problem with the vertical work clamp position.
Problem with work clamp motor home position adjustment data.
E303
Re-adjust the home position.
Communication and memory-related errors
Code
Connection communication error with power supply motor P. C. board detected when power was turned on.
E401 Turn off the power, and then check that connector P6 on the power supply motor P.C. board and connector P14
on the main P.C. board are properly connected.
Connection error with PMD P. C. board detected when power was turned on.
E403
Turn off the power, and then check that connector P1 on the PMD P.C. board is properly connected.
Communication error with main P. C. board detected.
E410
Turn off the power, and then turn it back on again.
Communication error with power supply motor P. C. board detected.
E411
Turn off the power, and then turn it back on again.
Communication error with PMD P. C. board detected.
E413
Turn off the power, and then turn it back on again.
E420 No CF card is inserted.
The program number is invalid or it has no corresponding data.
E421
Change the program number.
Error occurred while reading CF card.
E422
Check the data on the CF card.
Insufficient free space on CF card.
E424
Use a different CF card.
Error occurred while writing to CF card.
E425
Use the specified type of CF card.
R/W key has not been pressed.
E426
Press the R/W key to load the data.
Cause and remedy
Cause and remedy
Cause and remedy
KE-430D, BE-438D
9. TABLE OF ERROR CODES
(Continued on next page)
56