Sony KDP-57XBR2 Service Manual page 219

3. Enter the Service mode, and select
category "2150D- 1".
4. Adjust item # 0 "VPOS" so that the
picture is displayed in the center of
screen vertically.
5. Adjust item # 1 "VSIZ" so that the
vertical height is as shown above.
6. Select category "2150D- 2" and adjust
item # 1 "HPOS" so that the picture is
displayed in the center of screen.
7. Select category "2150D- 2" and adjust
item # 2 "HSIZ" so that the horizontal
width is as shown above.
8. After adjustment is finished, press the
"MUTING" + "ENTER" buttons on the
remote to write the data to memory.
9. Change to the WIDE ZOOM mode and
repeat steps # 6 - 8. This time, use only
side markers for position and width; do
not be concerned about the top and
bottom markers.
3-3 PJE MODE SUB-DEFLECTION
(COARSE AND FINE GEOMETRY
& CONVERGENCE) ADJUSTMENT
3-3-1 Functions of Keys on Remote
Commander
1 : Changes adjustment item (selects the next
higher adjustment item).
: Moves the fine-adjust mode position marker
clockwise from center to outside.
4 : Changes adjustment item (selects the next
lower adjustment item).
: Moves the fine-adjust mode position marker
counter-clockwise from the outside to the
center.
2 : Changes adjustment category (selects the
next higher category).
5 : Changes adjustment category (selects the
next lower category).
: Changes data value.
: Marker moves up, down, or to the left
or right. (in fine adjustment mode).
3 : Changes adjustment color:
GRN BLU
PJE items No. 00~ 77)
6 : Displays or changes internal test patterns:
crosshatch + video
+ borderline
only patterns off.
9 : Changes the sub-deflection ("PJE")
adjustment mode from coarse adjustment
mode to fine adjustment mode and back.
·
:
When pressed in, toggles the
method of moving the fine-
(press in)
adjustment mode marker around the
screen as follows:
When marker is white, move joystick
button up, down, and side to side
direction to move the marker
around the screen.
Press joystick button in and the
marker changes from white to red or
green or blue. Use the # 1 and # 4
buttons to move the colored marker
around.
Press the joystick button in again to
change the marker from a color
(red, green, or blue) to white.
16
RED (except for
crosshatch
crosshatch only dots