Setting Menu Items - JVC KW-AVX840 Instructions Manual

Setting menu items

• You cannot change <Audio> settings (except <Amplifier Gain>) when the AV source is turned off.
Menu item
Fader/Balance
Equalizer
Loudness
Crossover
Volume Adjust
Amplifier Gain*
You can change the setting only when the AV source is turned off.
*
Selectable setting/item
Fader : Adjust the front and rear speaker output balance.
z
F6 to R6; Initial 0
• When using a two-speaker system, set the fader to the center (0).
Balance : Adjust the left and right speaker output balance.
z
L6 to R6; Initial 0
Press [ 5/∞/2/3 ] or drag [
• To clear the adjustment, press [Center].
Change the sound mode or adjust and store the equalization for each source.
( page 37)
z
Flat/Natural/Dynamic/Vocal Boost/Bass Boost/Vibrant/User
You can activate/deactivate the loudness function.
z
Off : Cancels.
z
On : Boost low and high frequencies to produce a well-
balanced sound at a low volume level.
Adjust the cross over frequency. ( page 38)
Adjust and store the auto-adjustment volume level for each source. (For
discs, the adjustment is stored for each of the following categories: DVD/
DVD-VR, VCD/CD, and DivX/MPEG1/MPEG2/MP3/WMA/WAV.) The volume
level will automatically increase or decrease when you change the source.
z
–15 to +06; Initial 00
You can change the maximum volume level of this unit.
z
High : VOL 00 to 50
z
Low : VOL 00 to 30
(Select this if the peak power of the speakers is less
than 50 W.)
z
Off : Deactivates the built-in amplifier.
• If you change this setting from <High>/<Off> to <Low> while the
volume level is set higher than the maximum level of <Low>, the unit
automatically lowers the volume level to "VOL 30").
44
Initial: Underlined
] to adjust.