Top Chassis Brackets Removal; Pwb-Main Removal - Mitsubishi Electric WD-60C9 Service Manual

MODELS: WD-60C9 / WD-65C9 / WD-73C9 / WD-60737 / WD-65737 / WD-73737 / WD-82737
CHASSIS REMOVAL & DISASSEMBLY (Continued)
TOP CHASSIS
BRACKETS
A

Top Chassis Brackets Removal

NOTE: Removal of the Power Supply Shield and PWB-POWER is not required to remove the Top Chassis
Brackets.
1) Remove screws (A).
2) Disconnect all cables from the PWB-POWER.
3) Lift the Top Chassis Brackets from the chassis.

PWB-MAIN Removal

1) Disconnect all cables to PWB-MAIN.
2) Remove screws (A) from the DVI
connector.
3) Remove screws (B) from the Side
Terminals.
4) Remove screw (C) from the Side
HDMI connector (V41+ only).
5) Remove screws (D).
6) Lift the PWB-MAIN out of the
chassis.
PWB-MAIN Installation
1) Install screws (A) (B) and (C) first.
2) Then install screws (D).
3) Perform "Restore Engine Data From Backup" (See Data Transfer in Service Adjustments section).
4) Perform "Restore Geometry Data From Backup" (See Data Transfer in Service Adjustments section).
WD-65837 / WD-73837 / WD-82837
A
A
DVI
B
C
(V41+)
Page 9
A
D