Jenn-Air W2780 Use And Care Manual page 7

Clock Controls
When electrical power is supplied or after power interruption, the last clock time
displayed before power was interrupted will flash. Time will advance and continue to
flash until clock is reset.
To set time of day:
1. Touch Clock Pad.
Indicatorword TIME will flash and AM or PMand time digits will appear in the Display.
(If more than 10 seconds elapse between touching Clock Pad and turning the Set
Dial, the Clock Pad must be touched again in order to set clock.)
2. Turn Set Dial in either direction until correct time of day appears in Display.
NOTE: Three seconds after turning dial, time of day will automatically be entered.
Once the time is set, the AM or PM indicators will not show unless the Clock Pad
is touched.
To recall time of day when another time function is showing:
Touch Clock
Pad. (Note: AM or PM will not remain in the Display.)
To change time of day set on clock: Repeat above sequence.
NOTE: Clock time cannot be changed when oven has been programmed for Timed
Bake, Timed Convect or Self-clean. Cancel program before reprogramming clock.