Download Print this page

Connecting The Display - Nokia NWSP Assembly Instructions Manual

Wrist attached sensor platform
Hide thumbs

Advertisement

Copyright © 2008 Nokia Corporation
Figure 9 Adding the vibration motor.

1.5 Connecting the display

On top of the electronics assembly in locations shown in Figure 10 (ignore everything else in this
picture, as it is showing the development unit.), where there are no components on the circuit board
supports for the LCD display should be placed. These supports should be approximately 3mm high and
flexible. In this prototype three layers of 1mm thick double sided foam tape has been used.
NWSP Wrist Unit
Assembly Instructions
Tom Ahola 2008-05-15
10 (12)

Advertisement

loading

  Related Manuals for Nokia NWSP