9. Test light 11. Audiovox Series 640/650 Video Module NOT FOR VEHICLES EQUIPPED WITH SUN ROOF. INSTALLATION INSTRUCTION # 44-0031A INSTALLATION INSTRUCTIONS 50-0284x-015 SERIES 1181313 JEEP GRAND CHEROKEE 2. Powered screwdriver or drill with adapter 4. Razor knife or similar 6. Scissors 8.
Page 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, # 10 X 1/2" HWH SCREW, 6-32 X 3/4" PPH WASHER, 3.5 mm SCREW, # 8 X 1 1/2" PWH SCREW, # 6 X 1/2" PFH REAR MOUNTING BRACKET FRONT MOUNTING BRACKET CONSOLE SPEAKER GRILLE COVER PLATE COVER PLATE DECAL...
Page 3
FIGURE 1 3. Remove and retain (1) one screw which secures front O.E. console. Pull downward to release console. See Figure2. FIGURE 3 I. PREPARATION OF VEHICLE INTERIOR 1. Using the rear edge of O.E. console as a reference 4. Using a 3/8" drill bit, make an access hole in rear 5.
Page 4
8. Insert rear mounting bracket (item 6 pg. 2) with the bent edges downward. Slide bracket rearward between headliner and roof until tabs engage rear O.E. roof brace. Align slots in bracket with center line scribed on roof. See Figure 4. Note: There is a foam sealer between O.E.
Page 5
10. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar.
Page 6
13. Release video screen from locked position. Lower video screen to viewing position for access to mounting location in top of video system housing. 14. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instruction included with video system.