Page 2
The GL6 uses two woofers wired in parallel in a W-T-W arrangement; they combine to provide a focused vertical output and wide horizontal dispersion pattern.
Page 3
2. Strip approximately 1/2 to 3/4 of an inch off the ends and twist the strands together so there are no loose ends that can cause shorts. 3. Loosen the GL6 Speaker Terminals as shown in Diagram 3 so there is enough room between the post and the collar to feed the stripped wire through without damaging the strands.
PROTECTING THE HIGH-GLOSS CABINET FINISH The finish on the GL6 is a durable high-gloss Polymer coating, that while durable, should be carefully maintained. Do not place any hard object directly on the cabinet without first putting down a soft cloth or other nonabrasive pad. Do not place any liquid containers including drinks, flower vases or plants directly on the cabinet to avoid water marks.
Need help?
Do you have a question about the GL6 and is the answer not in the manual?
Questions and answers