Leveling Front Table - Craftsman 509344 Owner's Manual

Assembly
7. Stand the front table on one edge. Put a
mounting screw with a washer through each
of the mounting holes. Then put a rubber
grommet on the bottom of each mounting
screw.
8. Place the front table on the saw so that
the mounting screws line up with the U-clips .
The front table should extend about one inch
beyond the trim caps .
9. Start the mounting screws into the U-
clips using a Phillips screwdriver. Tighten the
screws until the heads are just touching the
table . Make sure that the table is not squeez-
ing the rubber grommets .
10. Start the leveling screws into the level-
ling holes using a 1/8 inch hex "L" wrench.
Tighten the screws until they are flush with
the table .
11. From the underside of the table attach
the table rails to the table board using the
two holes nearest the end of each rail.

Leveling Front Table

NOTE: The goal of this adjustment is to
make the front work table flat and parallel to
the radial arm . In order to do this, you will
choose four points on the table . When these
four points are level, the entire table should
be level.
1. Loosen the three leveling screws and be
sure that the five mounting screws are snug
but not overtightened.
2. Raise the radial arm until the bottom of
the motor is about 2-1/2 inches above the
front table .
18
Rubber
Grommet
Mounting
Holes
Front Table on Front Edge
Mounting
Holes
Mounting
Hole