Chapter 2 : Preparations; Preparing A Power Supply; Using A Battery Pack - Sony PMW-500 Operation Manual

Solid-state memory camcorder
Hide thumbs Also See for PMW-500:
Table of Contents

Advertisement

2
Preparations
Chapter
Preparing a Power
Supply
For safety, use only the Sony battery packs and
AC adaptors listed below.
• BP-L80S Lithium-ion Battery Pack
• AC power using the AC-DN2B/DN10 AC
Adaptor
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law
in the relative area or country.

Using a Battery Pack

When a BP-L80S Battery Pack is used, the
camcorder will operate continuously for
approximately 145 minutes.
WARNING
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
Note
The battery pack operating time depends on the
frequency of use of the battery pack, and the ambient
temperature when used.
Before use, charge the battery pack with a charger
suitable for each battery.
For details on the battery charging procedure, refer
to the battery charger operation manual.
Note on using the battery pack
A warm battery pack may not be able to be fully
recharged.
To attach the battery pack
1
Press the battery pack against the back
of the camcorder, aligning the line on
the side of the battery pack with the
matching line on the camcorder.
1 BP-L80S
2 Align these lines.
2
Slide the battery pack down until its
"LOCK" arrow points at the matching
line on the camcorder.
1 "LOCK" arrow
2 Matching line on the camcorder
Note
If the battery pack is not attached correctly, the terminal
may be damaged.
To detach the battery pack
Holding the release button in, pull the battery
pack up.

Preparing a Power Supply

33

Advertisement

Table of Contents
loading

Table of Contents