Korg Karma Basic Manual page 41

Listening to the program sound of just one timbre
G
Press the [F8] ("UTILITY") key to access the utility
menu, and press the [F7] key to choose "Solo
Selected Timbre." Press the [F8] ("OK") key.
Now you will hear only the program sound of the
currently selected timbre. The lower part of the LCD
screen will indicate [Solo].
To cancel this setting, choose "Solo Selected Tim-
bre" once again and press the [F8] ("OK") key.
Adjusting the stereo location of the sound
5 Select the Mixer page.
Press the [F3] ("Mix") key. Here you can adjust the
pan and volume for timbres 1–8.
6 Adjust the stereo location in "Pan" of timbre 2.
Use the cursor key [ ], [ ], [ ], [ ] to choose
"Pan" (highlighted) for timbre 2.
Use the controller to change the value.
A setting of C064 is center, L001 is far left, and R127
is far right. With a setting of RND, the stereo loca-
tion will change randomly between left and right
each time a note is played.
Adjusting the volume
7 Adjust the "Volume" of timbre 2.
Use the cursor key [ ], [ ], [ ], [ ] to choose "Vol-
ume" (highlighted) for timbre 2.
Use the [VALUE] controller to change the value.
Adjusting the volume while preserving the volume
balance between timbres
G
Press the [F8] ("UTILITY") key to access the utility
menu, and press the [F7] key to choose "Hold Bal-
ance." Press the [F8] ("OK") key.
The upper right of the LCD screen will indicate
"Hold Bal."
When you change the "Volume" value of any tim-
bre, the volume of all timbres will also change to
preserve the volume balance at the time you
checked the Hold Balance setting.
To cancel this setting, choose "Hold Balance" once
again and press the [F8] ("OK") key.
35