Remote Control; Remote Control Bz_Sics; Changing The Batteries - JVC AV-36260 User Manual

Remote Control
RM-C305
Remote Control Basics
• Before you can operate the remote control, you must first install
the batteries (included). See "Changing the Batteries" at the
bottom of this page for instructions. (For an illustration, please see
page 7.)
• Press the POWERbutton to turn the television on or off.
• Make sure the TV/CATV switch is set to TV. Move the switch to
CATV only if you need to operate a cable box.
• Slide the VCR/DVD selector switch to VCR to control a VCR,
slide to DVD to control a DVD player. Please see pages 18 to
20 for instructions on programming your remote control to
operate a Cable box, VCR or DVD player.
• Press the CH+ and CH- buttons to scan through the channels.
Tap the CH+ or CH- button to move through the channels one
channel at a time.
• To move rapidly through the channels using JVC's Hyperscan
feature, press and hold CH+ or CH-. The channels will zip by at
a rate of five channels per second.
• Press VOL+ or VOL - to raise or lower the volume. An indicator
bar will appear onscreen to show you the television volume
level.
• The CH+/- and VOL+/- buttons are also used to navigate JVC's
onscreen menu system.
• You can directly access specific channels using the 10-key pad.
• For more information on remote control button features, see
pages 40 to 45. For information on using the onscreen menus,
see page 21.
Notes: Remote control model RM-C305 is shown at the left.
A different model remote control may have come with your
television.
Changing the Batteries
Push down on the remote's back cover and slide towards the bottom to remove it.
Insert two AA batteries (supplied), carefully noting the "+" and "-" markings on the batteries and on
the remote control. To avoid a potential short circuit, insert the "-" end first. Be sure to use only size
AA batteries.
When batteries are installed, slide the cover back into place (until it clicks into position).
• If the remote control acts erratically, replace the batteries. Typical battery life is six months to one
year. We recommend using alkaline batteries for longer battery life.
When you change the batteries, try to complete the task within three minutes. If you take longer than three
minutes, the remote control codes for your VCR, DVD, and/or CalVe Box may have to be reset (see page 18-20).
17