Hitachi CD 14F Instruction Manual page 14

English
Untighten the wing bolt and move the side cover so that it is in alignment with the angle set. (Fig. 11)
Vise (B)
4. Moving the stationary vise-jaw (Fig. 14)
5. How to adjust 0 positon (Fig. 15)
Scale
Vise (B)
Indicator M10 Machine Screw
14
Side Cover
Wing Bolt
Cutting Material in case of angle or channel, to fix as Fig. 12
WARNING:
Fig. 13
The vise opening is set at the maximum of 7-5/16" (186 mm) when
shipped from the factory.
Vise (B)
In case an opening more than 7-5/16" (186 mm) is required, move
the vise-jaw to the position shown by the chain line, after
unscrewing the two bolts. The maximum opening can be set in
8-17/32" (217 mm).
When the material to be cut is excessively wide, the vise can be
effectively used by repositioning the stationary side of the vise jaws.
Fig. 14
The indicator is suitable for 0 positon of scale when shipped from
White Line
factory.
In case the vise (B) opening is move from 7-5/16" (186 mm) to
8-17/32" (217 mm) and so on.
Make adjust of 0 position as follows.
(1) Loosen M10 machine screw
(2) Adjust that white line of vise (B) is suitable for white line of
base.
(3) Adjust that indicator is suitable for 0 positio of scale
(4) Tighten loosened screw
Fig. 15
Vise (B)
Fig. 11
Fig. 12
Never fix as Fig. 13
If it is, the cutting material will move and cutting
accuracy will deteriorate.
Side Cover
Wing Bolt