Corded Base Station - AEG Solo Combo 15 User Manual

6.3 Corded Base Station (see P3 and P6)
# Icon
Press to go back to the previous message during message playback.
12
During a call, press to mute the microphone and press again to resume
conversation.
13 Press to cancel an action.
During pre-dialling or number editing, press to delete the last digit entered.
During number editing, press and hold to delete all digits.
During a call, press to send a Flash signal for network services.
14
In standby mode, press to access the Phonebook.
15
Hookswitch : press to end a call.
16
In standby mode, press and hold to playback message on the answering
17 machine.
Press to stop playback.
During message playback, press to skip to the next message.
18
In standby mode, press and hold to set date and time.
19 In settings mode, press to confirm a setting.
In standby mode, press to access the call log (CID).
In standby mode, press to enter the redial list.
20
When dialling, press and hold to add a dialling pause.
P
21
In standby mode, press and hold to turn the ringer On/Off.
In standby mode, press and hold to switch the key lock on or off.
22
Press to make or receive a call in speaker mode.
23
In standby mode, press to adjust ring volume.
24 + - During a call, press to adjust the speaker volume.
Press to browse through the phonebook or call log.
Press to find / page all registered handsets.
25 Press again to turn off the page signal.
Press and hold to start registration process.
Important:
In the event of a mains power failure, the cordless handsets will not work, and the display on the
corded base will be off, but the corded handset can still be used to make or receive calls.
The corded base will still ring if there is an incoming call, and the call can be answered with the
corded handset, but there will be a delay of up to 5 seconds after picking up the handset before the
handset becomes active and you can start a conversation.
Meaning
5