Toshiba W-603 Service Manual page 33

4-3-11 Assembly of Gear Loading Drive,
Slider Cam, Lever T, S Load Ass'y
1) When reinstalling, be sure to align dot of Lever T
Load Ass'y Œ with dot of Lever S Load Ass'y ´
as shown in drawing. (Refer to Timing Point 1)
2) Insert the Pin A, B, C, D into the Slider Cam ˇ
hole.
3) Be sure to align dot of Lever T Load Ass'y and dot
of Gear Loading Drive ¨. (Refer to Timing Point 2)
4) Align dot of Gear Loading Drive with mark of
Slider Cam as shown in drawing.
(Refer to Timing Point 3)
TIMING POINT 1
ΠLEVER T LOAD ASS'Y
TIMING POINT 2
TIMING POINT 3
PIN A
Fig. 4-18 Assembly of Gear Loading Drive,
Slider Cam, Lever T, S Load Ass'y
Toshiba
´ LEVER S LOAD ASS'Y
¨ GEAR LOADING DRIVE
LEVER T
LOAD ASS'Y
PIN C PIN D PIN B
ˇ SLIDER CAM
4-3-12 Lever Tension Ass'y, Band Brake Ass'y,
Sleeve Tension Removal
1) Remove the Spring Tension Œ.
2) In bottom side of Deck, remove the Sleeve Tension
´ after rotating it right or left as liftinig locking
edge of Sleeve Tension.
3) Remove the side "a" of the Band Brake Ass'y ¨ in
the direction of arrow "A" from the Lever Tension
Ass'y ˇ.
4) Remove the side "b" of the Band Brake Ass'y ¨ in
the direction of arrow "B" from the Main Base.
Note :
1) When replacing the Lever Tension Ass'y, be sure to
apply oil in the Sleeve Tension.
2) Take care not to touch stain on the felt side, and
not to be folded and broken Band Brake Ass'y.
ΠSPRING TENSION
LEVER S
LOAD ASS'Y
Fig. 4-19 Lever Tension Ass'y, Band Brake Ass'y, Sleeve Tension
Disassembly and Reassembly
a
"A"
b
"B"
¨ BAND BRAKE ASS'Y
ˇ LEVER TENSION ASS'Y
´ SLEEVE TENSION
Removal
4-11