Adjustment Instruction; Designation; Main Pcb Check Process - LG 32LH2000 Service Manual

1. Application Range
This specification sheet is applied to all of the LCD TV with
LD91A chassis.

2. Designation

1) The adjustment is according to the order which is
designated and which must be followed, according to the
plan which can be changed only on agreeing.
2) Power Adjustment: Free Voltage
3) Magnetic Field Condition: Nil.
4) Input signal Unit: Product Specification Standard
5) Reserve after operation: Above 5 Minutes (Heat Run)
Temperature : at 25±5ºC
Relative humidity : 65±10%
Input voltage : 220V, 60Hz
6) Adjustment equipments: Color Analyzer (CA-210 or CA-
110), DDC Adjustment Jig equipment, SVC remote
controller
7) Push The "IN STOP KEY" - For memory initialization.
Case1 : Software version up
1. After downloading S/W by USB, TV set will reboot
automatically
2. Push "In-stop" key
3. Push "Power on" key
4. Function inspection
5. After function inspection, Push "I n-stop" key.
Case2 : Function check at the assembly line
1. When TV set is entering on the assembly line, Push
"In-stop" key at first.
2. Push "Power on" key for turning it on.
-> If you push "Power on" key, TV set will recover
channel information by itself.
3. After function inspection, Push "In-stop" key.

3. Main PCB check process

* APC - After Manual-Insult, executing APC
* Boot file Download
1) Execute ISP program "Mstar ISP Utility" and then click
"Config" tab.
2) Set as below, and then click "Auto Detect" and check "OK"
message
If "Error" is displayed, Check connection between
computer, jig, and set.
3) Click "Read" tab, and then load download file (XXXX.bin)
by clicking "Read"
(1)
fi lexxx.bin
Copyright ©2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes

ADJUSTMENT INSTRUCTION

4) Click "Connect" tab. If "Can't" is displayed, check
connection between computer, jig, and set.
5) Click "Auto" tab and set as below
6) Click "Run".
7) After downloading, check "OK" message.
filexxx.bin
* USB DOWNLOAD
1) Put the USB Stick to the USB socket
2) Automatically detecting update file in USB Stick
- If your downloaded program version in USB Stick is Low,
it didn't work. But your downloaded version is High, USB
data is automatically detecting
3) Show the message "Copying files from memory"
- 9 -
(2)
Please Check the Speed :
To use speed between
from 200KHz to 400KHz
(4)
(5)
(7) .OK
(6)
LGE Internal Use Only
(3)